Ah, got it.93henfan wrote:Two holes were drilled all the way through from side to side. These were drilled over the rear axle. They sort of look like two fuel doors on each side, if you want to equate it to a real car. Does that make sense?JoltinJoe wrote:
Hey Hen, I'm doing this right now, and I'm going to plagiarize your successful design. I'm not sure what you mean by "six of the weights were drilled through and place over the rear axle."
Do you mean you drilled over the rear axle -- on the sides of the car ... three on each side?
Then we put three cylindrical weights (I think 1/2 oz each) in each of the holes, centered as best as possible, and glued in. Then put wood putty over the holes after the glue dries and sand to the best of your ability.
Here's a closeup. The other hole is obscured by the wheel:
Nothing beats a visual aid!






